Differences

This shows you the differences between two versions of the page.

--- public:radio:radio_database:th-d72 [29/03/24 09:01 GMT] – [Documentation] john
+++ public:radio:radio_database:th-d72 [08/04/25 18:29 BST] (current) – john
@@ Line 2: / Line 2: @@
-====== TH-D72 ======
+====== Kenwood TH-D72 ======
@@ Line 21: / Line 21: @@
 The display will show "Mobile Ctrl"
-  {{:public:radio:radio_database:2024-03-29_08.46.00.jpg?600|}}
+{{:public:radio:radio_database:2024-03-29_08.46.00.jpg?600|}}
 The TM-D710 must also be put in Remote Control mode.
@@ Line 28: / Line 28: @@
   * select VHF mode on both sides
+  * turn off the APRS TNC if it's on
   * set the left side to the wanted VHF Frequency
   * set the right side to the UHF Uplink/control frequency to match the TH-D72
+    * the first steps are done by selecting ''PM5'' on my TM-D710
+    * make sure the left side/VHF is the "active" side by clicking the left volume knob
   * turn off
   * hold ''Rev'' button
@@ Line 63: / Line 66: @@
   * To turn off Cross-Band Repeat
     * D
+Once the TM-D710 is in the correct condition - VHF Frequency, tone, power, cross-band repeat - it's possible to restore the TH-D72 to normal operation and use it to access the cross-band repeater and use DTMF tones as normal (eg. to control another system via the repeater). Just exit "Mobile Ctrl" mode on the TH-D72
+  * Turn off
+  * hold ''MR'' and ''PTT''
+  * Turn on
+You should be back in normal operation mode.
+Obviously, to control the TM-D710 again (eg to disable cross-band repeat) simply go back to ''Mobile Ctrl'' mode in the same way, and send the required commands.
 ===== Documentation =====
@@ Line 77: / Line 92: @@
 ==== tags ====
-{{tag>radio th-d72}}
+{{tag>radio thd72}}