<-[[.:start]] ====== GM4SLV Allstar ====== ** UHF Allstar Gateway ** ===== Hardware ===== |Platform|Rapsberry Pi| |Interface|CM108 Soundcard| |Radio|FT-8900| |Frequency|430.050MHz| |Monitor|[[http://gm4slv.plus.com:42111/allmon2/link.php?nodes=48148|Allmon2]]| |AllStar | [[http://stats.allstarlink.org/stats/48148]]| ===== Config ===== {{ :public:radio:gm4slv_allstar_config.tar | Config files }} ===== Commands ===== * DTMF Commands * Please send * 7 3 to ensure all links are disconnected before making any new links ^Command ^DTMF Sequence^ |Disconect from Node xxxx | * 1 xxxx | |Connect RX Only to xxxx | * 2 xxxx | |Connect Transceive to xxxx | * 3 xxxx | |Speak the Node Status | * 7 0 | |Disconnect ALL nodes | * 7 3 | |Reconnect ALL nodes | * 7 4 | |Send Node ID | * 8 0 | |Speak the Local Time | * 8 1 | |Parrot ON | * 9 1 | |Parrot OFF | * 9 2 | |Parrot ONCE | * 9 3 | ^ Name ^* 5 Macro shortcut to... ^ DTMF Sequence ^ Node No. ^ | Hubnet |Disconnect from Hubnet | * 5 1 1 | 41223 | | Hubnet |Connect RX Only to Hubnet | * 5 2 1 | 41223 | | Hubnet |Connect Transceive to Hubnet | * 5 3 1 | 41223 | ===== Courtesy Tones ===== Can give information about the node status. After a local Transmission on the "input" frequency the reponse will be one of: * Morse Letter **I** (di-dit) = node is not connected to any other nodes * Morse Letter **R** (di-dah-dit) = node is connected in "Monitor/RX only" mode to one or more nodes * Morse Letter **K** (dah-di-dah) = node is connected in "Transceive" mode to one or more nodes There are other tones, e.g. when a station on a linked node unkeys there's a low-pitched "bloop" When a local RF station sends a command there's a "bip bip" (not to be confused with the Morse letter I) ===== Echolink ===== AllStar nodes can also connect to [[https://www.echolink.org/logins.jsp|Echolink]] The node is occasionally connected to Echolink as ''GM4SLV-L '' (**UPDATE** --- //John Pumford-Green 24/04/23 14:47// ) I have disabled the Echolink connection by editing ''/etc/asterisk/modules.conf'' to change the channel driver for Echolink to ''noload'' -> To turn Echolink **ON** or **OFF** edit ''/etc/asterisk/modules.conf'' ** OFF ** noload => chan_echolink.so ; ** ON ** load => chan_echolink.so ; an Asterisk reload is necessary: gm4slv@mb7aze:/etc/asterisk$ sudo astres.sh Restarting Asterisk systemctl restart asterisk.service --- //John Pumford-Green 24/04/23 14:44// ===== Further Information ===== {{tag>radio allstar echolink}}