UHF Allstar Gateway
Platform | Rapsberry Pi |
Interface | CM108 Soundcard |
Radio | FT-8900 |
Frequency | 430.050MHz |
Monitor | Allmon2 |
AllStar | http://stats.allstarlink.org/stats/48148 |
* DTMF Commands
Command | DTMF Sequence |
---|---|
Disconect from Node xxxx | * 1 xxxx |
Connect RX Only to xxxx | * 2 xxxx |
Connect Transceive to xxxx | * 3 xxxx |
Speak the Node Status | * 7 0 |
Disconnect ALL nodes | * 7 3 |
Reconnect ALL nodes | * 7 4 |
Send Node ID | * 8 0 |
Speak the Local Time | * 8 1 |
Parrot ON | * 9 1 |
Parrot OFF | * 9 2 |
Parrot ONCE | * 9 3 |
Name | * 5 Macro shortcut to… | DTMF Sequence | Node No. |
---|---|---|---|
Hubnet | Disconnect from Hubnet | * 5 1 1 | 41223 |
Hubnet | Connect RX Only to Hubnet | * 5 2 1 | 41223 |
Hubnet | Connect Transceive to Hubnet | * 5 3 1 | 41223 |
Can give information about the node status.
After a local Transmission on the “input” frequency the reponse will be one of:
There are other tones, e.g. when a station on a linked node unkeys there's a low-pitched “bloop”
When a local RF station sends a command there's a “bip bip” (not to be confused with the Morse letter I)
AllStar nodes can also connect to Echolink
The node is occasionally connected to Echolink as GM4SLV-L
(UPDATE — John Pumford-Green 24/04/23 14:47 )
I have disabled the Echolink connection by editing
/etc/asterisk/modules.conf
to change the channel driver for Echolink to noload
→
To turn Echolink ON or OFF edit /etc/asterisk/modules.conf
OFF
noload => chan_echolink.so ;
ON
load => chan_echolink.so ;
an Asterisk reload is necessary:
gm4slv@mb7aze:/etc/asterisk$ sudo astres.sh Restarting Asterisk systemctl restart asterisk.service
— John Pumford-Green 24/04/23 14:44